Winter Concrete Care Checklist for Des Moines Homeowners
After the next fall rain, take a walk from your front steps to the street. Look for puddles near the garage, water running from a downspout across the sidewalk, and raised concrete edges that will be harder to spot under snow. If you park in the driveway, check the area where salty slush usually drips off your car.
Those are good places to start before winter in Des Moines. Use this checklist to see what you can take care of now and which cracks, low spots, or uneven sections are worth having looked at before they freeze.
Your Before-the-Freeze Concrete Checklist
-
Sweep leaves and dirt off your driveway, patio, sidewalks, and steps.
-
Check where water pools after rain and where your downspouts drain.
-
Look for cracks, flaking concrete, and uneven slabs.
-
Check whether your concrete needs resealing and whether the forecast gives you enough time to do it.
-
Get your shovel and traction sand ready. If your concrete is heading into its first winter, skip chemical deicers.
1. Clear leaves and dirt off your concrete
Sweep the driveway, patio, walkways, and steps so you can see the condition of the concrete. Move planters and outdoor mats and check underneath for damp spots or flaking. If you have a stamped concrete patio, sweep around furniture legs and along the edges where leaves collect in the texture.
2. Check where water goes after it rains
Look for standing water near the garage door, at the bottom of the front steps, and where the patio meets the house. Water that sits on these surfaces can turn into ice when temperatures drop.
Clear clogged gutters and check that your downspout extensions direct water away from the foundation and off walking surfaces. If you keep seeing a puddle in the same spot after redirecting a downspout, take a photo while the water is still there. A low spot or grading issue may need a closer look.
3. Look for cracks, flaking, and uneven slabs
A narrow, stable crack with even edges may be a candidate for an exterior concrete crack sealant. Follow the product instructions for cleaning, application temperature, and cure time.
If one side of a crack is higher than the other, a sidewalk panel rocks underfoot, or a patch keeps opening back up, have the area looked at before covering it again. Pay special attention to raised sidewalk edges and loose concrete on steps, since snow can hide both.
If youâre seeing widespread cracking or sinking in the driveway, see our guide on whether to repair or replace your concrete driveway.
4. See whether your concrete needs resealing
A compatible exterior sealer can help reduce water absorption. The right product depends on the finish and whatâs already on the surface. A stamped patio may need a different product from a broom-finished driveway. If youâre unsure what was applied before, ask your installer before adding another coat.
Check the forecast before you start. Follow the manufacturerâs instructions for surface dryness, air and concrete temperatures, and how much time the sealer needs before rain or freezing weather. If the forecast is already too cold, wait for a suitable weather window.
5. Get ready to clear snow and handle ice
Clear snow before it gets packed down by cars or foot traffic. A plastic-edged shovel can help reduce scraping on decorative concrete. If you use a snow blower, check that the scraper and skid shoes are adjusted to avoid gouging the surface.
If your concrete is going into its first winter, avoid chemical deicers and use sand for traction. Sand adds grip on icy areas. Pay attention to the garage apron and the spots where road salt and slush drip from parked vehicles.
How to Fill Small Cracks in Sidewalks and Front Entry Concrete
If you find a small crack in your front walk or entry landing and the concrete is firm and even on both sides, you can usually seal it yourself. Sealing helps keep water and debris out before winter.
- Clean out the crack. Use a stiff brush and a shop vacuum to remove dirt, grit, and loose concrete. Let the area dry if the sealant instructions call for a dry surface.
- Choose an exterior concrete crack sealant. Check the label to make sure it covers your crack width. Use a self-leveling sealant on a flat sidewalk or landing. For a sloped walkway or the vertical face of a step, choose a non-sag sealant that will stay in place.
- Apply the sealant. Use a caulk gun to lay a steady bead along the crack. Follow the label for how deep to fill it and whether to smooth the bead. Keep the sealant flush with or slightly below the walking surface.
- Give it time to cure. Pick a dry day within the productâs temperature range. Check for overnight frost, and keep foot traffic off the area for as long as the label directs.
Check the spot by your front door before you seal it. A straight gap where the landing meets the house may be an intentional joint. Use a flexible exterior joint sealant if that joint needs resealing, and keep any drainage openings at the door threshold clear.
If one side of the crack sits higher than the other, the concrete is loose, or a step moves underfoot, have it looked at before filling the gap. Those are signs the concrete itself may need attention.
Have concrete damage you want checked before winter?
If your driveway is sinking, your patio holds water, or your front walk has shifted, take a few photos before the snow arrives. Include a wide shot of the whole area and close-ups of the damage so we can see where itâs happening.
TRW Concrete Construction works with homeowners in Des Moines and the surrounding metro. Explore our concrete driveway services or call 515-554-3606 to talk with us about your concrete project.
