Can You Epoxy a Cracked or Pitted Garage Floor?

Yes, many cracked or pitted garage floors can be epoxy coated after the concrete is repaired and prepared. The deciding factor is whether the slab is sound. A shallow pit where salty slush drips off your car is a different problem from a crack with one side sitting higher than the other.

Before choosing a finish for your Des Moines garage, take a closer look at what’s happening underfoot.

Which garage floor cracks can be repaired before epoxy?

Start by looking at both sides of the crack. If the edges are even and the crack has stayed about the same over time, it may be possible to fill it with a repair material compatible with the coating system. The repaired spot can then be prepared along with the surrounding concrete.

If the crack is widening, the edges have shifted, or a previous patch keeps opening up, have the slab evaluated first. Movement can cause a repaired crack to show through the finished floor again.

You may also see straight, evenly spaced grooves across the garage. These may be intentional control joints. Ask how the installer plans to handle them, especially if you want a smooth, continuous look.

Can you coat a pitted or flaking garage floor?

Shallow pits and localized surface wear can often be repaired before coating. Look near the garage door and where your tires usually sit. If the damage is concentrated in those spots and the surrounding concrete is firm, the floor may be a good candidate for resurfacing and coating.

If the concrete is flaking across large areas or crumbles when you sweep it, the installer needs to determine how much sound material is underneath. Loose concrete has to come off before a repair or coating can bond to the floor.

What if the garage floor has oil stains, peeling paint, or damp spots?

  • Oil stains. Point out dark spots under parked vehicles. Oil can soak into concrete and affect how well a coating bonds, so those areas may need extra prep.
  • Peeling paint or an old coating. Show the installer where it’s lifting and share what product was used, if you know. Loose or incompatible material may need to be removed.
  • Recurring damp spots. Tell the installer if the same spot keeps getting damp, especially when the garage has been empty and dry weather rules out snowmelt from your car. Moisture should be evaluated before choosing a coating system.

What does preparation look like before coating?

The installer evaluates the slab, removes loose material and any coating that interferes with adhesion, and prepares the concrete so the new system can bond. Repairable cracks and pits are addressed with products compatible with the coating. The exact steps depend on the condition of the floor and the system being installed.

When you compare quotes, ask which repairs are included, how the surface will be prepared, and whether any cracks or joints may still be visible after installation.

Have TRW take a look at your garage floor

If you’re unsure whether your floor can be coated, take one wide photo from the garage door and close-ups of the worst spots. For a crack, take a second photo from the side if one edge is higher. Mention any old coating, previous repairs, or damp spots that keep returning.

TRW Concrete Construction installs epoxy flooring in Des Moines and the surrounding metro. Call 515-554-3606 or contact TRW about your garage floor.